Videos

Akupanel Headboard Installation

4 minutter

Akupanel Celing Installation

2 minutter

Akupanel Adhesive Installation

3 minutter

Akupanel – installation guide

Download pdf Print

In the downloadable PDF you will find detailed step-by-step instructions for installing the acoustic panels.

Or you can follow the individual points below.

Steps 5 and 6, cutting the panels to size, need only be carried out if necessary. If the measurements fit for you, you will be finished after step 4 and can look forward to your result.

Akupanel_installation_wall_needed_materials

Materials needed for assembly:

A saw – either a circular saw or a normal saw (foxtail)
A screwdriver
Screws for the Akupanels and the underlying battens
» Black screws approximately 35 mm. for mounting the Akupanels
» You will potentially need small screws (approximately 15 mm.) for fixing the
lamellas on the filt when after cutting the panels in length
» Screws and plugs for mounting the battens on the wall
Battens (we recommend 45 mm. in thickness)
Mineralwool (45 mm. i thickness)
A scale
Pencil

Step 1: preparing the wall

remove coarse impurities
remove screws, nails etc.

Akupanel_Installation_Wall_mounting_the_batterns

Step 2: Mounting the underlying battens

Airst fix the battens to the wall to screw the screws through the felt of the acoustic panels into the battens (plugs and screws may be required)
We recommend a distance of 40 cm between the slats
then insert the mineral wool between the laths on the wall (sound insulation class A)
alternatively, the acoustic panels can also be mounted directly on the wall with screws or
glue (sound insulation class D)

Note: If the acoustic panels are glued directly to the wall, you may damage the wall and/or the panels if the panels are detached.

Akupanel_Installation_Wall_Insert_mineral-wool

Step 3: Insert mineral wool between the battens

Insert a 45 mm thick mineral wool (or similar to the thickness of wooden slats) between the slats
This can be cut with a knife and is then clamped between the slats

Step 4: Mounting the akupanels

use black screws (35 mm) to screw through the black felt into the batten
recommendation: 15 screws per acupanel

The panels have one side with felt and one with lamella
When assembling in continuation to each other, please note that the felt side of the one panel is seamless with the slat side of the following panel
this creates a joint of about 12 mm between the slats of the two panels

Step 5: Cutting the Akupanels in width

At the end of the wall, the panels may have to be adjusted

Akupanel_Installation_Wall_cutting_width

Cutting the acupanel by cutting the felt with a sharp knife (e.g. cutter knife)

Fix the last acoustic panel to the wall with black screws through the felt

Step 6: Length Cutting

Cut the length of the acupanel with a saw
Mark the cutting line on the board with a pencil
After cutting, we recommend to fix the slats back on the felt
A screw (approx. 15 mm) is screwed through the felt on the back of the panel into the slat
Then repeat for each slat

Akupanel_Installation_Wall_cutting_Length

Congratulations!

Your wall is now fully installed.
The acoustics of the room are now much better and the reverberation is removed, so you can relax and listen to the words of your guests more easily.
If you need help with the installation, please do not hesitate to contact us.

We would be very happy if you send us pictures of your unset project or mark us in the social media.

Have fun with your project!

Did you find what you need?

Send us some feedback on this article